CBT Ball Separator

by Rope Fashion

CBT Ball Separator
image © 2004 Lynn Grant

This is a rope ball separator, similar to the commercial leather ones, but with several advantages. Here is an example of the commercial leather ones:

The rope version has the advantage that it always fits. The leather ones have snaps, and while they might have multiple snaps for adjustment, the range of adjustment is not very wide. And there's always the danger of getting a flap of skin caught in the snaps, which is really painful.

This one always fits, is inexpensive, and can be made on the spot from a short length of cord.

Step 1

Step 1
image © 2004 Lynn Grant

To make the ball separator, you will need a few feet of cord, like parachute cord or sash cord. You could probably use long leather bootlaces, but they have a lot more resistance and tend to bite into the skin uncomfortably. And, of course, you will need a cock and some balls. Here we are using a fake cock and balls, since we can't show real ones on the website. The ball separator is a lot more effective and impressive when you are using the real thing.

When you are tying this, be sure to check with your partner about how tight to tie it, since different men like different amounts of tightness and/or pain.

Step 2

Step 2
image © 2004 Lynn Grant

Start by making a large overhand knot in the cord.

Step 3

Step 3
image © 2004 Lynn Grant

Slip the loop over the cock and balls, with the place where the ends cords cross at the bottom.

Step 4

Step 4
image © 2004 Lynn Grant

Bring the ends around to the top of the balls, cross one end over the other, and pull them snug

Step 5

Step 5
image © 2004 Lynn Grant

Now take one of the ends, and run it under the two cords that go around the cock and balls on one side.

Step 6

Step 6
image © 2004 Lynn Grant

Slowly (so as not to cause rope burn) pull on the end until you have a loop a few inches in diameter.

Step 7

Step 7
image © 2004 Lynn Grant

Take both ends of the cord that crosses under the other two cords, and gently pull the crossing down so it is at the bottom of the balls.

Step 8

Step 8
image © 2004 Lynn Grant

Now we do the same thing on the other side. Take the remaining cord end and run it under both cords that go around the cock and balls.

Step 9

Step 9
image © 2004 Lynn Grant

Slowly pull on the end till you have a loop a few inches diameter.

Step 10

Step 10
image © 2004 Lynn Grant

Grabbing both sides of the cord that goes under the other two cords, gently pull it down so it is at the bottom of the balls, next to the one you did on the other side.

Step 11

Step 11
image © 2004 Lynn Grant

Running the cord ends under the ropes around the cock and balls will have loosened them, so pull the ends of the loops at the top of the balls snug.

Step 12

Step 12
image © 2004 Lynn Grant

Bring the two loops together, running them between the balls.

Step 13

Pull on the cord ends coming out below the balls until the two loops disappear and the balls are separated. This works much more effectively with real balls than it does with the monoball on our fake cock.

Step 14

Pull the two cord ends out to the sides.

Step 15

Bring them around to the top of the balls and cross one end over the other.

Step 16

Pull them snug.

Step 17

Now cross the ends the other way, making a square knot.

Step 18

You can continue bringing the ends around under the balls, then crossing them at the top. Each turn will put a little more pressure on the balls. You can continue this till you run out of cord, or you can take the ends and use them as a leash, or tie marling-hitches around the cock with them. (See the Marling-hitch CBT tutorial.)